2 ml 0 9% NaCl solution The viability

of the cells was o

2 ml 0.9% NaCl solution. The viability

of the cells was over 95% as determined by a trypan blue dye exclusion test. Then tumor tissue was cut and implanted subcutaneously to establish tumor bearing mice. Six to 10 days after implantation when subcutaneous tumor nodules reached approximately (120.5 ± 18.2) mm3, tumor model was successfully established and subjected to MK5108 cost Electric fields stimulation protocols. SPEF Exposure System SPEF generator was designed by Sun et al., Givinostat ic50 in the key laboratory of high voltage engineering and electrical new technology of Chongqing University [9]. The pulse curve was in form of unipolar exponential decay with the utmost voltage peak value 1000 V, pulse rise time ranging from 90–180 ns, pulse total duration 1–20 μs, and the frequency 1 Hz–5 kHz. Parameters in combination produced desired energy-controllable SPEF. Electric Fields Stimulation Protocols We used Tektronix TDS3032B Oscilloscope to monitor SPEF output and typical waveform captured referred to Figure 1. The parameters used for in vitro experiment referred to Table 1 : eight unipolar exponential decay pulses with each 20 μs duration (rise time was 160 ns), with amplitudes from 50 to 400 V/cm, and pulse repetition frequencies of 1, 60, 1 000, 5 000 Hz were delivered (cell exposure time was 30 minutes). Table 1 The parameters of SPEF used in SKOV3 cell suspensions. Test group Frequency (Hz) Intensity (V/cm) Rise time (ns)

Duration (μs) Stimulation

time (minutes) Group PFT�� solubility dmso Suplatast tosilate 1 1 50, 100, 150, 200, 250, 300, 350, 400 160 20 30 Group 2 60 50, 100, 150, 200, 250, 300, 350, 400 160 20 30 Group 3 1 000 50, 100, 150, 200, 250, 300, 350, 400 160 20 30 Group 4 5 000 50, 100, 150, 200, 250, 300, 350, 400 160 20 30 In the first procedure, each intensity constituted a separate experiment contained in a certain test group, and cell exposure time was 30 minutes for each intensity corresponding to a given frequency. Figure 1 Typical waveform of SPEF captured by Tektronix TDS3032B Oscilloscope. The parameters used in SKOV3 implanted tumor referred to Table 2 : eight unipolar exponential decay pulses with each 20 μs duration (rise time was 160 ns), with electric field intensity 250 V/cm, and pulse repetition frequencies of 1, 60, 1 000, 5 000 Hz were delivered (cell exposure time was 30 minutes). Table 2 The parameters of SPEF used in SKOV3 implanted tumor. Test Group Frequency (Hz) Intensity (V/cm) Rise time (ns) Duration (μs) Exposure time (minutes) test 1 1 250 160 20 30 test 2 60 250 160 20 30 test 3 1 000 250 160 20 30 test 4 5 000 250 160 20 30 In the second procedure, each frequency constituted a separate experiment, and tumor exposure time was 30 minutes for each frequency. In this paper, we adjusted, the frequency of the pulses by changing the interval between two consecutive pulses in a train, and then keeping both the duration and number of pulses constant.

Comments are closed.