24 hours after incubation, cells were treated by PTL at indicated concentrations for 48 hours; then the medium was removed and 200 μl of fresh medium plus 20 μl of 3-(4,

5-dimethylthiazol-2yl)-2, 5-diphenyltetrazolium bromide (MTT, 2.5 mg dissolved in 50 μl of dimethylsulfoxide, Sigma, St. Louis, MO, USA) were added to each well. After incubation for 4 hours at 37°C, the culture medium containing MTT was withdrawn and 200 μl of dimethylsulfoxide(DMSO) was added, followed by shaking for 10 minutes until the crystals were dissolved. Viable cells were detected by measuring absorbance at 570 nm using MRX II absorbance reader (DYNEX Technologies, Chantilly, Virginia, USA). The cell growth was expressed as a percentage of absorbance in cells with PTL treatment to that in cells without PTL treatment (100%). The inhibition rate (IR) was calculated as follows: IR = (1-A value of buy Barasertib PTL well/A value of ITF2357 solubility dmso control well) Caspase cleavage × 100% Flow Cytometry 1 × 105 cells suspended in 2 ml fresh media were plated in each well of a 6-well flat-bottomed microtiter plate and incubated overnight. Then PTL with indicated

concentrations were added. After 48 hours cells were harvested and washed twice with pre-cold PBS and then resuspended in 1× binding buffer at a concentration of 1 × 106 cells/ml. 100 μl of such solution (1 × 105 cells) was mixed with 5 μl of annexin V-FITC and 5 μl of Propidium Iodide (PI) (BD Biosciences, San Jose, CA, USA) according to the manufacturer’s introduction. The mixed solution was incubated at room temperature (25°C) away from light for 15 minutes. Then 400 μl of 1× dilution buffer was added to each tube. Analysis was performed by Beckman Coulter FC500 Flow Cytometry System with CXP Software (Beckman Coulter, Fullerton, CA, USA) within 1 hour. DNA fragmentation analysis BxPC-3 cells (1 × 106 cells) were seeded in 6-well microtiter plate. Then the cells were treated with the indicated concentrations of PTL for 48 hours. For analysis of genomic DNA, attached and nonattached cells in the supernatant were harvested and collected C1GALT1 together.

DNA was extracted by the DNA extraction kit (QIAGEN, German) according to the manufacturer’s instruction. 5 μg of DNA was separated on a 2% agarose gel. DNA in the gel was stained with ethidium bromide, visualized under UV light, and photographed. Wound closure assay Cells were plated in 6-well-plates. When the cells grew into full confluency, a wound was created on the monolayer cells by scraping a gap using a micropipette tip and then PTL with indicated concentrations were added immediately after wound creation. The speed of wound closure was compared between PTL treated groups and the control group (PTL untreated cells). Photographs were taken under 100× magnifications using phase-contrast microscopy (OLYMPUS IX70, Olympus, Tokyo, Japan) immediately after wound incision and at later time points as showed. Cell invasion assay A Transwell cell culture chamber (Millipore, Bedford, MA, USA) with a 6.